A commercial fire alarm system was developed that was to be intelligent to meet the modern needs (Hussam, 2012). His primary purpose for the system was to provide an early warning of fire so that Fire alarm systems at the Seattle campus are maintained by Campus Engineering and Operations. As a result the University has found it cost effective to develop specific standards for design, installation and acceptance of fire alarm systems. The standards include a sole-source justification A fire alarm bell or sounder can also be set to different volume levels, frequencies and tones depending on the country standards and manufacturer of the device. Fire alarm electronic devices are known as horns in both the United States and the Philippines and can be either continuous or set to different codes. The fire control panels are classified as either a conventional fire alarm system must have communication features and therefore must provide visible fire alarm systems. The fire alarm system in a residential dwelling unit must extend to a point within the unit that is near the smoke detection system. Accessible smoke alarms are also required for residential facilities. The smoke alarm system can be integrated with the fire FIRE PROTECTION ENGINEERS R.P. SCHIFILITI ASSOCIATES, INC. P.O. Box 297 Reading, Massachusetts 01867 - 0497 USA 781.944.9300 Fax / Data 781.942.7500 Telephone rpsa File: Sample Fire Alarm System Calculations.DOC Page 1 05 October 2000 Sample Fire Alarm System Calculations 1. - A fire alarm call point should also be spaced so that one may always be found within a maximum distance of 30m apart. 11 3- ALARM ITEMS: The minimum sound level of a sounder device should be 65dB (A) or 5dB (A) above a background noise (if lasting more than 30 seconds) and at a frequency between 500Hz and 1000Hz. to meet the application requirements of wireless automatic fire alarm system, based on the analysis of the applicable sites of wireless fire alarm system and the characteristics of communication Fire Alarm System Control Panels • Fire Control Panel: Contractors shall provide a programmable central fire control panel with addressable field devices and voice evacuation capabilities. The fire control panel shall meet NFPA 72 detector sensitivity readout/printout requirements. Alarm System, for a single panel to the complete fire alarm network. FAMS can also be used for Conventional Fire Alarm systems, where they are able to communicate Fire and Fault activity for a site, but there will be limitations of systems functionality. Some of these FAMS products are also capable of remotely disabling fire alarm equipment, FIRE PROTECTION FIRE EXTINGUISHION FIRE ESCAPE 3 FIRE PROTECTION HEAT OXYGEN FUEL FIRE TRIANGLE SMOKE HEAT SMOKE DETECTOR HEAT DETECTOR FIRE ALARM 4 FIRE EXTINGUISHION WATER CO 2 / INNERT GAS/ FOAM FIRE HOSE+NOZZLE SPRINKLERS CO2 SYSTEM, FIRE EXTINGUISHER AQUEOUS FOAM FILM HEAT OXYGEN FUEL FIRE TRIANGLE SEPARATE 5 TYPES OF FIRE FIGHTING SYSTEMS All other parts of the Fire Alarm system shall activate the fire alarm system and its programmed function. Page 7 OKLAHOMA STATE UNIVERSITY ADDRESSABLE FIRE ALARM SYSTEM STANDARD ENVIRONMENTAL HEALTH & SAFETY Revised: 3/14 3.1 PRODUCTS 3.2 General: A. All materials, equipment, accessories, devices and other facilities and appurtenances covered The Fire Alarm system (FAS) is implemented in building to reduce hazardous causes of fire. This System continuously monitors the space covered by zones. If