Galaxy DX Radios DX99V Documentation Project CBTricks.com Frequency Counter PCB (EPT210014D) (Started with later 2005 Production) EPT210014D Trace Layouts Schematic Diagram. Ref# Description. MFR. Part No. EPT210014D Counter PCB Complete with Components. #T-118W1-P03 User Manual. 3 year Warranty. The 10 Meter 45 Watt Galaxy Radio DX99V2 has the same features of the DX99V and the same main circuit board used in DX98VHP. The DX99V2 has a ton of features like a Blue LED display for Channel and Frequency Digits, Talkback circuit with on /off switch, Red Modulation Lamp, Front Microphone Jack; and High SWR Alert The new DX99V2 is the only Galaxy all mode mobile radio. It operates on AM/FM/LSB/USB. With dual MOSFET finals (instead of four or eight finals) the DX99V2 draws less than 10 amps and can be hooked up anywhere a standard radio is wired no special heavy gauge wiring is required. The front mic jack allows this radio to fit into tighter spaces Discontinued Download Manual The New DX-99V2 is the only Galaxy All mode mobile radio that operates on AM-FM-LSB-USB. It is also the only SSB mobile with no extra amplifier installed. With dual Mosfet finals (instead of 4 or 8 finals) the DX-99V2 draws less than 10 amps and can be hooked up anywhere standard radios are wired. No special heavy wire. Galaxy has reworked their popular DX99V with higher output power, and a more durable construction. The dual MOSFET finals give the Galaxy 99V2 approximately 50 watts modulation and up to 12 watts dead key. This updated Galaxy DX 99V2 CB radio with echo offers the same features with many improvements over the older model. Including more Galaxy DX Radios DX99V Documentation Project CBTricks.com . Main PCB (EPT360014B) (EPT360014C) Potentiometers. Ref# Bd Loc. Description: MFR. Part No. VR1. B4. S/F/R l0K OHM L. RE10300009. VR2. B4. S/F/R l0K OHM L. RE10300009. VR3. F3. S/F/R 500K OHM L. RE50400021. VR4. F4. S/F/R 500K OHM L Mode to AM. Unkey radio PWR/SWR/RB switch to SWR. Key radio. Connect wattmeter / 50-ohm resistive dummy load to ANT output. Remove 50-ohm dummy load and connect 100-ohm 100 watt load to radio antenna output connector. PWR Control. VR1. Adjust to max (65 watts). Adjust for 2:1 reading on radio SWR scale.